CLICK HERE FOR THE PRODUCT REVIEW BY TEAM JUNGLE ! This is the new Xecuter LT Switch v1.5 - the latest version in the #1 selling Xecuter LT Switch range. Xecuter has designed a simple switch for all the Liteon drives that enables firmware full read/write. They have also included an ON/OFF Led to show correct operation when switching to 0x72 vendor mode. Now Includes MULTI-R Function. After the discovery that a small number of Liteon drives would not dump the fw with a 20 ohm resistor - but required an 18 Ohm or 22 Ohm resistor - so you can now select between 18, 20 and 22 Ohms ! (Default should be set to 20 Ohms - this will work 99% of the time) The installation is very simple and takes about 5 minutes if you have some small experience with a soldering iron. I...

IN STOCK NOW !!! IMPORTANT NOTE: Xecuter have allowed us a small amount of stock without the conductive glue that will be included with the Probe v2 ! So all those of you who can simply repair the trace cut with your own glue or solder can now get your hands on one of these bad boys. But hurry the stock is very limited. Another bonus for the delay is that Xecuter improved the design by adding a MULTI-R switch (some Liteon drives will not read the firmware with a 20 Ohms resistor, but will only work with an 18 Ohms or 22 Ohms resistor - so now you can choose between all three ! - they have also added extra support for the Liteon Windbond IC that other products have problems with. Of course as usual, Xecuter products have none of these problems :) After the ama...