Date Added: Thursday 09 September, 2010 Manufacturer: Team Xecuter
Xecuter have released the latest in their line of LT Switch Liteon DVD mod products, the LT Clip + LT Switch v2.
This kit has been designed with the beginner in mind. It's been in development for a while due to the absolute precision and stability needed to make sure it works for the the lifetime of the DVD Drive with no soldering or glue for trace repairs. There is even included a built in continuity tester to make sure your trace cuts are perfect !
Also Includes MULTI-R Function. After the discovery that a small number of Liteon drives would not dump the fw with a 20 ohm resistor - but required an 18 Ohm or 22 Ohm resistor - so you can now select between 18, 20 and 22 Ohms ! (Default should be set to 20 Ohms - this will work 99% of the time)
This is the first and onl...
Date Added: Wednesday 08 September, 2010 Manufacturer: Team Xecuter
$37.95
We are official resellers for the much anticipated Minimus AVR USB Development Board !
We have tested this and it works prefectly. It is very easy to program and can be updated at any time without fuss. Unlike other poorly designed AVR Kits, all the IO's are accessible, there are power and status LED's and includes a real USB male connector for easy plug and play action.
Presenting Minimus, a high quality production grade AVR USB Development Unit that is clean in design, low in cost and readily available to resellers around the globe. There are hundreds of projects available for the AVR USB hobbyist looking for a powerful yet cost effective solution. Works with Open Source LUFA USB firmware library and Open Source LibUSB software library.
The Minimus AVR USB is powered ...
Date Added: Wednesday 07 April, 2010 Manufacturer: Team Xecuter
CLICK HERE FOR THE PRODUCT REVIEW BY TEAM JUNGLE !
This is the new Xecuter LT Switch v1.5 - the latest version in the #1 selling Xecuter LT Switch range.
Xecuter has designed a simple switch for all the Liteon drives that enables firmware full read/write. They have also included an ON/OFF Led to show correct operation when switching to 0x72 vendor mode.
Now Includes MULTI-R Function. After the discovery that a small number of Liteon drives would not dump the fw with a 20 ohm resistor - but required an 18 Ohm or 22 Ohm resistor - so you can now select between 18, 20 and 22 Ohms ! (Default should be set to 20 Ohms - this will work 99% of the time)
The installation is very simple and takes about 5 minutes if you have some small experience with a soldering iron. I...
