Author Topic: Soldering through hole  (Read 6326 times)

Offline SYSTEM aka (Cyberpyrot)

  • Site Founder
  • Acidmods Alumni
  • Around the block
  • *
  • Posts: 4091
  • Post quality +3/-0
  • Gender: Male
Soldering through hole
« on: January 22, 2008, 12:08:40 PM »
Soldering Through Hole 101


Low Quality for 56k


Here is High Quiality for broadband


Materials:

1: Solder
2: Flux Paste
3: Soldering Iron (15w beginners 30w advanced)
4: PCB (Printed Circuit Board)
5: Through Hole Componants





Step 1: Arrange the through hole componants in there proper position on the PCB once there properly aranged proceed to step 2.





Step 2: Flip the pcb over then carefuly bend the through hole feet outward so the componant is firmly secure in place making soldering to PCB very simple.





Step 3: Apply flux past to the feet and pcb board so as the solder will stick to both surfaces. Now place the tip of the iron on the PCB surface to be soldered. Now with the solder touch the sorounding area until a bead forms be careful not to apply to much solder or to get solder on the surrounding pins. Clean the tip of the iron between solders to prevent a cold solder joint. In the image all points on the left side are correct solder joints. In the image on the right are comon mistakes points 1 & 2 are insufficient solder in point 3 the solder was applied to the tip of the foot joining two holes and in point 4 there was excessive solder applies creating a cold solder joint.




Step 4: Once all soldering is complete use your snipping tool to remove the excess length on the componant feet. Your solder points should look like the joints above on the left side.
« Last Edit: September 04, 2010, 07:48:13 AM by modded matt »

Offline PSPotential

  • Chaos Lover
  • *
  • Posts: 271
  • Post quality +0/-0
  • Gender: Male
  • [I Am] {The} (Arctic) <Soldier>
Re: Soldering through hole
« Reply #1 on: January 22, 2008, 12:49:20 PM »
Perfect! Thank You Cyber!

Cheers For The Sig Indy! :)

Offline King Wolf 15

  • ½ Pint
  • *
  • Posts: 35
  • Post quality +0/-0
  • Gender: Male
Re: Soldering through hole
« Reply #2 on: February 08, 2008, 11:11:02 PM »
Awesome...
Thanks for the tutorial

Offline cwn723

  • Granny Spanker
  • *
  • Posts: 430
  • Post quality +0/-0
  • Gender: Male
Re: Soldering through hole
« Reply #3 on: February 18, 2008, 04:47:48 PM »
good tut

Offline RoBot1ks

  • Club AM VIP
  • Acid Modder
  • *
  • Posts: 671
  • Post quality +0/-0
  • Gender: Male
  • 1 r n00ber
    • Myspace
Re: Soldering through hole
« Reply #4 on: February 18, 2008, 04:59:00 PM »
Yeah thanks Cyber, I could really use this...... :tup:

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal