Author Topic: Clear Case Help  (Read 1561 times)

Offline Sgt Lovin

  • Motor Mouth
  • *
  • Posts: 90
  • Post quality +0/-0
  • Gender: Male
  • My PSP is Unmodded still :(
Clear Case Help
« on: May 18, 2008, 08:58:17 AM »
Ok, here's the Problem:

My Coolmods clear case doesn't fit very well with all my PSP parts, the motherboard off a little to the right and the screw for it wont go in.

once i put together my PSP, i tried turning it on it but it wouldn't turn on, so i pished the power switch in and up and what do you know it lit up. But once i turned it on the green power LED would start fading away, so put pressure on the PCB board and the green LED got brighter.

Ok, once all of the above was done, i put the LCD brace and it fit very well, but when i tried putting the faceplate it wouldn't close from the top right corner, i got the top left corner of the PSP to close by   putting some good pressure on it and it did, but i was scared of breaking the right side.

Any one had this problem with the clear case before?

Any info would be appreciated, Thanx


Offline MARIOPARTY53

  • I DONT FAIL
  • BANNED
  • E = MC² Mad Scientist
  • *
  • Posts: 1526
  • Post quality +0/-0
  • Gender: Male
  • Pc Gaming Rules
Re: Clear Case Help
« Reply #1 on: May 18, 2008, 08:59:51 AM »
yeah, I hate installing those clear cases, they need so much cutting its not even funny
However today I was brutally raped by a door handle, and none of my friends helped me up off the floor after ten minutes, instead they all teabaged me, all 10 of them...

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal