razor x help

[Sanctus]

I know where to solder to on my slim psp but I just don't know how to assemble the razor x(with  the spring) and what I need to solder on my razor x. I tried search but didn't find anything. Can someone tell me how or point me in the rite direction?

[tanoz]

you solder the 4 wires on the backside of the razor x pcb and they will then be soldered to the psp.
to assemble the nub you simply completly dismantle a psp nub and then take the spring, the part that connects to the nub cover and the top half of nub(part you pull apart). you then assemble just those three parts like you would as normal and put on your razor x pcb. move it around to make it sit in place and the razor x board should be flat against the plastic. then using heat melt mushroom down the 4 legs to the pcb and that holds it together

[Sanctus]

you solder the 4 wires on the backside of the razor x pcb and they will then be soldered to the psp.
to assemble the nub you simply completly dismantle a psp nub and then take the spring, the part that connects to the nub cover and the top half of nub(part you pull apart). you then assemble just those three parts like you would as normal and put on your razor x pcb. move it around to make it sit in place and the razor x board should be flat against the plastic. then using heat melt mushroom down the 4 legs to the pcb and that holds it together

Thanks. I'm trying to do it but im stuck at the spring xD I can't see how to get the dam thing on. Any tips? 

[tanoz]

there is a video somewhere showing how to get it in. let me find it and then later ill edit this post giving you the link.

edit: finally found it
 http://youtube.com/watch?v=fmSydaJpCYw

[Sanctus]

Yea I still can't get it though >.> I'll try again I guess xD

[Jumbo]

BTW Tanoz didnt say to ground the razor dont forget to ground it to any - point on the psp  Good luck

[Sanctus]

Alright i got the spring  And I wired up my razor but when i go to connect it to the pins on the mobo they wont stick properly >.> Its probably because they are to small for a descent connection?