Fitting the razorX

[longcat1]

so how do u fit the board in there? the screw thing is in the way and the board is overlaping some of the x button.

[Jumbo]

you gotta dremel that out....

[ryan0]

you gotta dremel that out....

what he said......lol,i recommend chopping what you dont need from the powerboard,theres actually alot u can take off without interfering with the buttons,it makes it much easier than not cutting the pwoerboard,also cut the screwhole on the faceplate,dremel a square for the analog nub to fit snugly into the faceplate,chop out the clip that holds down the bottom of the powerboard to the backplate,basically chop what you can

[longcat1]

awww i dont have a dremel, o well i guess i can  cut and sand for a year, thx for the help

[Tri-edge]

if your really careful you can melt it with your soldering iron

[longcat1]

well i managed to cut it with an xacto so yay but does anyone kno how to make a good hole cuz i tryed drilling but i lost a faceplate

[Ch4rL13]

well i managed to cut it with an xacto so yay but does anyone kno how to make a good hole cuz i tryed drilling but i lost a faceplate

ehh well this is where the dremel would come in, i would guess you draw a circal the best u can and dremel that out, or maybe you could melt a whole wit ur iron and sand the melted part out? lol

[Jumbo]

You eitehr need a dremmel or a mill to cut that out. I would suggest sending it to somebody. I got a faceplate from ryan0 cut on his milling machine it was perfect :P