Author Topic: Led Light under a button...  (Read 1644 times)

Offline rinsaku

  • Chief squatting Hard
  • *
  • Posts: 25
  • Post quality +0/-0
Led Light under a button...
« on: August 05, 2008, 03:19:03 AM »
Im planning on putting a led on my O button...

do you think I can do this? and yeah /\ X and [_] will be normal buttons...

Offline tmandt

  • Club AM VIP
  • E = MC² Mad Scientist
  • *
  • Posts: 1544
  • Post quality +1/-0
  • Gender: Male
  • o.O tOny! JDMKID
Re: Led Light under a button...
« Reply #1 on: August 05, 2008, 08:52:39 AM »
yes you can do it. this has been done many times

Offline l0rdnic0

  • 2%
  • Acidmods Alumni
  • E = MC² Mad Scientist
  • *
  • Posts: 1836
  • Post quality +8/-0
  • Gender: Male
  • TeamCYBER

Re: Led Light under a button...
« Reply #2 on: August 05, 2008, 10:13:18 AM »
Look in the TUT section I have one posted up there.. :#1:


L0rdNiC0 Pioneering Mods on the PSP Slim :taunt:
Sound Mod, Button LED Mod, Security Mod, Dual NUB, Mode Select Switch + More

Offline rinsaku

  • Chief squatting Hard
  • *
  • Posts: 25
  • Post quality +0/-0
Re: Led Light under a button...
« Reply #3 on: August 05, 2008, 06:03:24 PM »
ummm... Im thinking of where I could put my led...

and I dont want it to be sound reactive... and I dunno where should i put it.. and Im thinking where I gonna drill on my button...xD

Offline Sanctus

  • Acid Modder
  • *
  • Posts: 606
  • Post quality +1/-0
  • Gender: Male
Re: Led Light under a button...
« Reply #4 on: August 05, 2008, 09:46:24 PM »
ummm... Im thinking of where I could put my led...

and I dont want it to be sound reactive... and I dunno where should i put it.. and Im thinking where I gonna drill on my button...xD

Do some research, it's all been done.

Offline rinsaku

  • Chief squatting Hard
  • *
  • Posts: 25
  • Post quality +0/-0
Re: Led Light under a button...
« Reply #5 on: August 06, 2008, 01:01:54 AM »
yeah I already saw it... So I just need a 40 ohm resistor if I gonna make a direct wiring for my O button to be non reactive on a 5v points...

so L&R leds will go with the LM386 on the Anode + and my unreactive O button will go to either 3v or 5v with 40 ohm resistor on power switch board?

and All of my Cathode will get bridge to the wire of Wifi Switch...

I am just thinking where does the Ground pin on LM386 goes?

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal