rapid fire issue

[dansterdan]

 did whole thing all works but when put case back on and screw in right and top left but after that if i screw any more it just makes Lt action on. only when gets to certain point. give some advice please.

[Skullmaster]

More than likely a wire is pinched making a short

[dansterdan]

could be ill check that. IT piss me off though because it works and then right as I screw it in tight it Wont stop its like holding the LT down. but Lt is up.

[KingMike_OS]

Who's Kit is that .. not ours .. Hmm Looks like ebay kit.  ???

[Hazer]

That resistor looks like it is in the way of the Dpad. It may be gettiing pushed to one of the vias.

Also, one of your power wires has way too much bare wire showing and looks like it also could be pinched by the Dpad.

[Winterz117]

yeah hazer is right it looks like you need to move the resistor a bit, just bend it up towards the analog stick.

[dansterdan]

I ll move the resistor and see if that dose the trick

[blackburn]

yeah like others have said the only real issue i can see is the resistor....  i doubt this could be an issue, but some of the soldering is a bit thick (large beads) and it could be causing a shot but i cant really think of anything that it could touch.  I would just try moving the resistor first 

[blackburn]

yeah like others have said the only real issue i can see is the resistor....  i doubt this could be an issue, but some of the soldering is a bit thick (large beads) and it could be causing a short somewhere but i cant really think of anything that it could touch.  I would just try moving the resistor first 

[dansterdan]

Thank you guys i fixed the problem it was partly the resister and the rumble was making the button touch other side.