Just finished a new controller (blue tiger)

[Ghost In Black]

I've been working on this for a few days now and just finished it. Side note: The xbox guide button also lights up red when the rumble is activated, and I installed 3 mode rapid fire with LED notification. Unfortunately I couldn't tape this because my Xbox DVD drive broke. (I'm going to my friends this weekend and then I'll edit this post with the new video.)
http://www.youtube.com/watch?v=Mdz3rYdWKoI
EDIT: Went to my friend's house and got the red rumble and LED rapid fire notification also:
http://www.youtube.com/watch?v=oW8w8SJw_yg

[zbblanton]

wow that is awesome so clean and shiny 

what did u paint it with spray paint or what?

im also working on a blue tiger controller got the base blue done.
got any tips?

[Ghost In Black]

Sure, I painted it with duplicolor spray paint. I had lots of coats- I think 2 primer 4 blue 2 black and 2 clear coats. I put only a light coat on each time though, and made sure it was dry before the next coat was applied. Oh, and I sanded the blue with high grit sandpaper. Lol this is my second controller because I messed the first one up by sanding the black; not very smart. It was easier to restart than sand the first controller back down. Good luck

[bustinthejustin]

wut'd u use to mask the design? This is awesome!

[Ghost In Black]

Thanks! I just put some blue painters tape on my desk (which is like a cutting board) and cut a design in it. It does take a while but it's not too hard.