Author Topic: Need help with 3 & 5v points and MS issue  (Read 1208 times)

Offline enixidfrag

  • Motor Mouth
  • *
  • Posts: 84
  • Post quality +0/-0
  • Gender: Male
Need help with 3 & 5v points and MS issue
« on: February 05, 2009, 08:42:30 AM »
Ok so i'm working on a VERY BIG project. But I need help with two pieces

#1 I need the 3v & 5V Spots so i can do the rumble mod

#2 I desoldered the MS slot and and at one point i had it working but its no longer working i had to reolder a few times now i'm not sure if maybe a fuse blew or something for the MS and if so idk where it is.

Offline RoBot1ks

  • Club AM VIP
  • Acid Modder
  • *
  • Posts: 671
  • Post quality +0/-0
  • Gender: Male
  • 1 r n00ber
    • Myspace
Re: Need help with 3 & 5v points and MS issue
« Reply #1 on: February 05, 2009, 09:28:43 AM »
3v:

For the positive on the powerboard, you must take an exacto knife or something sharp and gently remove the green layer revealing a layer of positive copper

5v:


About the memory stick problem- Do you have a picture?
 :tup:

Offline rceckspurt13

  • Acid Modder
  • *
  • Posts: 637
  • Post quality +2/-0
  • Gender: Male
Re: Need help with 3 & 5v points and MS issue
« Reply #2 on: February 05, 2009, 09:37:44 PM »
That contact on the powerboard is actually 3.6 volts and not just 3 I think. I'm not too sure about the memory thing either.
Any Questions? Please Contact Me: rceckspurt13@gmail.com

Offline Jumbo

  • Dr. Mod
  • BST BAN
  • Around the block
  • *
  • Posts: 2399
  • Post quality +0/-3
Re: Need help with 3 & 5v points and MS issue
« Reply #3 on: February 07, 2009, 01:27:24 PM »
I actually get 5 volts off the powerboard...

And make sure there is no bridging in the Memory slot reader.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal