« previous next »
Pages: [1]   Go Down

Author Topic: Location & Size of hole for rapid fire button  (Read 888 times)

Offline Dylon889

  • Chief squatting Hard
  • *
  • Posts: 11
  • Post quality +0/-0
Location & Size of hole for rapid fire button
« on: February 02, 2009, 04:11:25 AM »
I ordered a chip that is coming in and I was wondering where and what size of whole I should drill in to the controller.
Thanks.
Logged

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: Location & Size of hole for rapid fire button
« Reply #1 on: February 02, 2009, 04:28:15 AM »
that will depend on what type of button you use, and what its function will be
Logged

Offline moeiscool

  • Ω Allumnist Ω
  • *
  • Posts: 139
  • Post quality +0/-0
  • Gender: Male
Re: Location & Size of hole for rapid fire button
« Reply #2 on: February 02, 2009, 06:49:08 PM »
grab your drill bit and put it on top of your buttons see if it looks just about the size
or use your smallest drill bit, make a hole
and keep moving up on drill bit sizes until your button fits snug.
Logged
PLEASE DONT USE REFERRAL BANNERS IN YOUR SIG
Signed
Mac
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal