Switches?

[alentris]

So i bought a bunch of dip switches, cut one off, dissassembled my psp, and now... Where the f can i put a dip switch?? i have a slight idea, but where do people regularily put them?

[EliteGamer83]

Cut a small square/rectangle hold on the trip and put them anywhere you can fit them along the trim, I suggest at the bottom cause there's alot of room there.

[pspupgrade]

Yes, it would be best on the trim. Another good place is the top right of the PSP; plenty of space there to put in a switch.

[rgarjr]

Look around, some dudes put them in the UMD area so that you can't see them. 

[GhoSt]

Under the battery cover, the little egde bit that makes the gap next to the powerboard.

[alentris]

Under the battery cover, the little egde bit that makes the gap next to the powerboard.

Would it fit there? mine's like 5mm, not including pins (which could prolly be bent of course)

[EliteGamer83]

Well I wouldn't recommend putting it in the battery cover, gonna be a hassle to turn on and off, I would say stick with putting them in the trim, that's how most everyone does it alot easier to access too. 

[alentris]

Well I wouldn't recommend putting it in the battery cover, gonna be a hassle to turn on and off, I would say stick with putting them in the trim, that's how most everyone does it alot easier to access too. 

kk, but where in the trim??

[W-Gaming5]

 

[rceckspurt13]

The trim is the silver strip that goes all around the outside of the psp. There is a liege space to the right of the pobo above the power switch. That is where I would put it.

[EliteGamer83]

You can also put it at the bottom under the button strip.

[redrider]

I personally think that the best spot is to just mount is in the UMD drive. The reason I think this is because It is easier to do then cut the trip or the case itself. But thats just my opinion. And even better is to just wire it to the wifi switch. I like to keep things clean and simple with using what I have other than complicating things by adding more components. But thats just me

[alentris]

I personally think that the best spot is to just mount is in the UMD drive. The reason I think this is because It is easier to do then cut the trip or the case itself. But thats just my opinion. And even better is to just wire it to the wifi switch. I like to keep things clean and simple with using what I have other than complicating things by adding more components. But thats just me

Unfortunately, direct contact can't use a universal ground

[Blazinkaos]

just place it in the umd area righ next the to the lock that open the umd door..