« previous next »
Pages: [1]   Go Down

Author Topic: 2n2222 SR mod question...  (Read 1003 times)

Offline thearkman2009

  • Registered BST
  • E = MC²
  • *
  • Posts: 332
  • Post quality +2/-0
  • Gender: Male
  • Designing Innovative Mods
    • SteelROMs
2n2222 SR mod question...
« on: March 31, 2009, 07:58:42 PM »
I have a question about the 2n2222 NPN SR mod method.

I notice that in the diagram there is no resistor between the power source and the transistor (except for the LED of course).  Wouldnt this burn out the LED?  If not, would be be possible to tap the power source from a 3.6 volt place, run through a switch, through two LEDs, and into the transistor?
Logged

Offline GhoSt

  • Creating Null
  • Around the block
  • *
  • Posts: 2552
  • Post quality +19/-0
  • Gender: Male
  • Null Pointer Exception
Re: 2n2222 SR mod question...
« Reply #1 on: March 31, 2009, 08:35:04 PM »
Quote from: GhoSt_Death on March 30, 2009, 10:06:03 PM
technically its not 5v the way we are using it, its 5v between ground, I just stated it as that because then people know where to solder to. Use a multimeter across the rumble/leds on it and you will see it staying around 1.7v
Logged
|Variegation - GhoSt's Final Controller|

|Nothing is deterministic.|
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal