Help making the 360 sync light sequence on ROL run continuously.

[arbiter918]

I need help making the light sequence that the sync button runs run continuously. I've seen this done before and think it would be cool, any help would be much appreciated.

[Modded Matt]

?? never heard this request before. I would assume you could bridge all the green power points so they all run from the #1 led power point, but you will need to cut the supply trace so nothing gets back fed into the system. you can use the power from the center LED also

[Rory]

I think he means like, where they light up one at a time. In order of:
Top Left, Top Right, Bottom Right, Bottom Left (repeat).

I saw this in the PSP section, where this guy stuck a load of LEDs in his clear UMD door, and had them spinning clockwise. Looked sick, that was ages ago though...

Forgotten the name of them :/.

[Modded Matt]

that is in the programing of the sinc function. this can be done with a chaser program....I think Chives just finished one as amatter of fact..IDK. as for just lighting them you can hot wire them as I stated above to keep them all on all the time.

[Rory]

Chaser... *Headdesk*

How could I forget :P.

I don't know about Chives' latest antics, I'm not online as much as I used to be :P.