Console Modding------ ( Here you can talk about your favorite Consoles ) > 360 Controllers / 360 Rapid Fire Controllers

Install diagrams for Original Acidmods Rapidfire products

(1/2) > >>

802Chives:
COD World At War RapidFire Kit On triggers CG Install:
Pin out : Please ignore the colors just look at the Picture For Reference as your wire may be Diffrent color

802Chives:
COD 5 Sleeper Matrix Install:
*Warning* This install requires an advanced skill level. This mod involves scraping very delicate wire traces on the circuit board and could result in PERMANENT damage to your controller. Acidmods is not responsible for any damage that is caused when attempting this install.

here the Pin Out : Sleeper COD 5












Hot Glue Can Help Hold Your Wire In place after You Solder Them.

802Chives:
COD World At War RapidFire Kit On triggers  Matrix Install:Pin out : Please ignore the colors just look at the Picture For Reference as your wire may be Diffrent color




This is Example again ignore the Wire Colors Please make sure that the LED4 is bottom and LED 3 is Top

802Chives:
COD 5 Sleeper CG Install:
*Warning* This install requires an advanced skill level. This mod involves scraping very delicate wire traces on the circuit board and could result in PERMANENT damage to your controller. Acidmods is not responsible for any damage that is caused when attempting this install.

here the Pin Out : Sleeper COD 5


Led Pin 7


D pad Point for On/Off Rapid Fire Pin 3

802Chives:
COD4 3-MODE INSTALL(Rapid Reload) -Matrix
Made by Gameroms


i decided to do a install with the new COD4 3-MODE kit, heres a link to the new kit

https://acidmods.com/ShopUSA/product_info.php?products_id=88

******NOTE*******
I'M DOING INSTALL BEFORE ALL MY SURFACE MOUNT PARTS GET HERE, SO I WILL BE USING 1/8 RESISTORS.  ALL KITS WILL COME PRE-ASSEMBLED WITH ALL SURFACE MOUNT PARTS.

******NOTE******
pay close attention to the guide, i got the orange and brown wires mixed up.  brown is supposed to go to right trigger, and orange goes on back of controller pcb with the blue and yellow.

Navigation

[0] Message Index

[#] Next page