Console Modding------ ( Here you can talk about your favorite Consoles ) > 360 Controllers / 360 Rapid Fire Controllers

Install diagrams for Original Acidmods Rapidfire products

<< < (2/2)

802Chives:
DUAL RAPIDFIRE PCB KIT INSTALL -Matrix

802Chives:
COD4 3-MODE INSTALL(Rapid Reload) -CG
I JUST MADE A SIMPLE GUIDE WITH PICS TO SHOW YOU HOW I WIRE IT, AND TRY NOT TO CONFUSE ANYONE.  IF YOU HAVE ANY QUESTIONS PLEASE POST IN THIS THREAD AND MIKE, CHAD OR MYSELF WILL HELP YOU.



BUMP MUST BE SANDED FOR BOARD TO LAY FLAT ON CONTROLLER.


WIRE COLORS AND JUMPER LOCATIONS FOR CG.


SWITCHES INSTALLED AND WIRES ATTACHED TO BOARD.


THIS IS HOW I RUN MY WIRES.


ALL WIRES ATTACHED TO CORRECT LOCATIONS.


X, Y, LED CONNECTION POINTS.


GND, +V, RIGHT TRIGGER CONNECTIONS.


SWITCH LOCATIONS.


LED WORKING AND COMPLETE.

802Chives:
DUAL RAPIDFIRE PCB KIT INSTALL -CG
Must sand bump before board will lay flat.


PCB labeled with colors.


All wires installed.  Left and rRight Trigger wires ran down each side of controller.


Wire cut to length needed.


PCB wired.


Button location.


Complete.

Navigation

[0] Message Index

[*] Previous page