Has anyone tried the razor nub using the washer?..

[akomismo01]

anyone tried it?.. do you have problems?.. because miine is rough and not very sensitive.. any way to fix it?. i already tried tinning but it will make it rough..

which one is the best to use? the spring method or the washer?

[Blazinkaos]

I thought the spring was good as long as you do it right of course.

[akomismo01]

i broke one spring because of doing it.. if i turn my analog up the spring moves.. not only the a part of the spring, but all the spring moves.. help?..

[Blazinkaos]

If its doing that then you must have the analog secured and closed well enough to keep the spring in its place.

[akomismo01]

@Blazinkaos thank you very much!..

[Jumbo]

The spring is very tricky just use clamps and glue it and let it dry fully and make sure the solder job is very smooth or it can pull the spring and mess it up and you may have to rebuild the razor (Big nightmare i have done it manyyy times lol)

[akomismo01]

thanks for the advice jumbo.. i broke one..:'( and its my onLy extre.. i'LL have to order again.. gues i'LL do it nicely next time..

[TeaBubblez]

buy some springs and trim it to size? xD