Console Modding------ ( Here you can talk about your favorite Consoles ) > 360 Controllers / 360 Rapid Fire Controllers

Wired CL (Common Line) Controller Button/Analog Traces

<< < (4/4)

Peloquin:
Thank you.

cn0098:
I lifted all of my USB pads while attempting a USB type C mod install. Got this exact board, but it seems like there's no TP for the USB lines... is there a way of repairing it (could you point out where the scrapping off should be made in order to bridge this)?

RDC:
The vias for D+ and D- are right above the pads you removed or use the left side of the Resistors R4 (D+) and R5 (D-) on the other side.

cn0098:


This is my current progress. I must admit, it's not as clean as I had hoped, but this is how it stands now, so no turning back.

I also accidentally cut the VCC line in half while being a bit too rough with the cutter (oops, smh)...



So now, the plan is to set up a jumper wire from one side to the other of the VCC line. Instead of just scraping off one section for the VCC, there will be two, one above and one below the lifted pad.





Finally all of it would be tied to the 2.54mm pins from the USB-C mod piece. In the end in theory this is a good thing because the pins are much easier to wrap around with a jumpwire and solder to. But i'll need some more tools to do this. It turned out to become a much harder mod than it should've been.

Navigation

[0] Message Index

[*] Previous page