Console Modding------ ( Here you can talk about your favorite Consoles ) > 360 Controllers / 360 Rapid Fire Controllers

Wireless CG2 Traces

(1/2) > >>

RDC:
TOP



BOTTOM


TP1 - N/A
TP2 - Ground
TP3 - B+
TP4 - Ground
TP5 - B+
TP7 - Ground
TP8 - Analog Voltage, 1.5v (Switched)
TP9 - DR
TP10 - Light Rumble
TP11 - Heavy Rumble
TP12 -
TP13 -
TP15 -
TP16 - N/A
TP17 - Ground
TP18 -
TP19 -
TP20 -
TP21 - USB D- (PnC Cable)
TP22 - Ground
TP23 - USB D+ (PnC Cable)
TP26 -
TP400 - Ground
TP405 - Antenna
TP407 - Ground

LED TRACES

Rodent:
Would anyone know if they have pic showing the trace for the leds on cg2 or is it the same a cg?

Anonamous:

--- Quote from: Rodent on December 10, 2011, 03:38:07 AM ---Would anyone know if they have pic showing the trace for the leds on cg2 or is it the same a cg?

--- End quote ---

It is most likely not the same bro.

DarkSydeCraZe:
Noob here.  How would I solder/hookup a wire to the holes (eg. the Y button).
I was planning on wiring a momentary switch to it. 
Any reply is greatly appreciated.

FOOKz™:

--- Quote from: DarkSydeCraZe on December 20, 2011, 09:31:04 PM ---Noob here.  How would I solder/hookup a wire to the holes (eg. the Y button).
I was planning on wiring a momentary switch to it. 
Any reply is greatly appreciated.

--- End quote ---

Take sandpaper and sand the green part off of your circuit board to expose the copper trace underneath.

Navigation

[0] Message Index

[#] Next page