« previous next »
Pages: [1]   Go Down

Author Topic: SMD Trace Repair?  (Read 2006 times)

bradleyh

  • Guest
SMD Trace Repair?
« on: April 10, 2010, 12:19:01 PM »
To make a long story short, i ripped the anode trace off of the 3rd player light in my controller. is this fixible?
Logged

Offline TokyoDrift

  • Motor Mouth
  • *
  • Posts: 95
  • Post quality +0/-0
  • Gender: Male
    • TokyoDrift's Development Blog
Re: SMD Trace Repair?
« Reply #1 on: April 10, 2010, 01:08:26 PM »
yes
you scrape the grean thing off the trace on a place it's not broken and solder a little wire to it
solder the other end to the LED and it's fixed ;)
TD
Logged

Offline 802Chives

  • Sargeant at Arms
  • Acidmods Alumni
  • Millennium Poster
  • *
  • Posts: 1304
  • Post quality +10/-0
  • Gender: Male
Re: SMD Trace Repair?
« Reply #2 on: April 10, 2010, 08:31:25 PM »
Logged

Offline nathd

  • Chief squatting Hard
  • *
  • Posts: 23
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: SMD Trace Repair?
« Reply #3 on: April 11, 2010, 03:59:24 AM »
I did the same and without sounding like a complete idiot, I followed the trace to the hole it leads to and soldered there, avoided and scraping etc. Many thanks, Nathan.
Logged

bradleyh

  • Guest
Re: SMD Trace Repair?
« Reply #4 on: April 17, 2010, 11:02:47 AM »
nice ideas. should i use an xacto knife for this?
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal