Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
And to reset it you have to turn off the controller?
this code sounds awsome.... but one question.... how accurate is the speed adjust cos i've notice with a prog kit i have that as little as 0.1sps can make all the difference in how well the rf works.....????but still i look forward to testing this code out....
well i just checked with both pads.. (matrix/cg1) and still the same result......and before its said there is nothing wrong with my install.... as i took out hazers BMU and re-flashed it with this code. and BMU was fine.....i'll take the chip out again download the hex again... and test again on a new pic..... i can make a vid of my results if needed..... aswell as pis of the install..... fingers crossed it is only a dodgy chip where its been soldered to and re flashed a few times lol...... ill find out in 15 once i've reflashed nd re-testedPost Merge: February 22, 2010, 07:59:02 AMok so i just did the re-flash.. and still the same issue with the burst mode.....and also i noticed on GOW2 that the fire rate isnt very good.... are you using the 25%/75% duty cycle that hazer used to get round the cod 5 patch... because this makes rapid fire on GOW2 dodgy.....and i beleive this could be causeing the problems with burst mode.. cos when hazer first released BMU3 i set a pic up with a 3 shot burst with the duty cycle and it didnt like it... and would only work on cod5 but would get capped sometimes....??????????
try this one
.... but still this is a great rf
ok robbo i tested that test.hex a min ago....and firstly was it ment ot be only 1 mode none adjustable (dual trigger....)
awsome robbo. ill test this out on both pad types again.. and make a video of it for you to ad into your main post if ya like Post Merge: February 28, 2010, 07:05:57 AMhi robbo just done a test of this code again... on halo 3 with a matrix pad.... and it all works fine.... i dont have a copy of cod 5 to test o see if mode 3 works past the patch.. but i guess it will...how ever i did notice a bug withthe dual trigger mode...... (mode 1)ok turn pad on.....select mode 1pulll right trigger = it fires right gunpull left trigger = it fire left gunpull both triggers = it fires both guns.adjust speed on mode 1 tp 11.2 spsnow pull left trigger no rapid fire.pull right trigger both guns rapid fire....scroll through all modes back to mode one and left and right triggers are back to bing indepent...is this a intentional akimbo mode ???either way its pretty cool being able to fire both guns on the 1 trigger..... i really like this code robbo you've done a great job on it
hmm i think its odd knowone has taken a interest in this code cos its awsome....... if i could code this is similar to my idea of a ultimate rf code.......