PulseVU 2 Installation [TUT/VID]

[Josho]

Sucks!

Wonder why....

[Wallydraigle]

Lots of good info here.  I've favorited this for when I install mine.  One question, though.  The picture in step 5 where you show where you soldered the ground wire doesn't seem to work.  Can you post that again please?  Well, two questions.  What are those three pads for on the bottom of the PulseVU board?

[Timmy]

Well just in case your problems have not been solved for some reason lol

a) Yes you can use the LED as a source for PO but you must use the negative
b) Yeah that soldering iron should do
C) You don't have to use that ground in step 5....srsly....any ground in the ds lite will do man
d) Don't worry about them read the sickmods site if you really want to know