« previous next »
Pages: [1]   Go Down

Author Topic: Help with Programmer  (Read 2371 times)

Offline SpartanXx666xX

  • Chief squatting Hard
  • *
  • Posts: 19
  • Post quality +0/-0
Help with Programmer
« on: July 16, 2010, 10:22:36 PM »
guys i just bought a programmer at mcumall

http://www.mcumall.com/comersus/store/comersus_viewItem.asp?idProduct=3141

but when i try using Hazers flex code i get an error says Received Data error.

I went through and saw that the Error is from the EEPROM Data.

Good at 0x2B04
Bad at 0x0000 --> EEPROM Data

any help would be appreciated
Logged

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: Help with Programmer
« Reply #1 on: July 17, 2010, 07:07:16 AM »
what software r u using?
Logged

Offline SpartanXx666xX

  • Chief squatting Hard
  • *
  • Posts: 19
  • Post quality +0/-0
Re: Help with Programmer
« Reply #2 on: July 17, 2010, 09:48:41 AM »
it comes with its own software. USB PIC Programmer. and it wont work with winpic800.

Also i get an error saying The programmer does not recognize the [12F683] processor continue anyway?

not sure why it cant recognize my chip....

have you used this programmer before matt?

« Last Edit: July 17, 2010, 10:09:36 AM by SpartanXx666xX »
Logged

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: Help with Programmer
« Reply #3 on: July 17, 2010, 01:38:47 PM »
nope try picit. are you sure you have the chip in the correct location?
Logged

Offline SpartanXx666xX

  • Chief squatting Hard
  • *
  • Posts: 19
  • Post quality +0/-0
Re: Help with Programmer
« Reply #4 on: July 17, 2010, 07:54:16 PM »
EDIT: i got it working now
« Last Edit: July 18, 2010, 10:39:20 PM by SpartanXx666xX »
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal