Author Topic: Stuck Trigger  (Read 892 times)

Offline Tyler89--

  • Chief squatting Hard
  • *
  • Posts: 19
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Stuck Trigger
« on: June 06, 2010, 07:06:27 PM »
Is there a tut for taking off the triggers? Better yet is there a trigger assembly breakdown. I have a controller that appears to have stuck trigger, shoots on it own. It's the ultimate rapid fire, till you run out of ammo.

Offline buickgnx

  • gba modder
  • Granny Spanker
  • *
  • Posts: 451
  • Post quality +0/-0
  • Gender: Male
    • www.MactasticMendezisawesome.com
Re: Stuck Trigger
« Reply #1 on: June 06, 2010, 07:36:38 PM »
have you tird pulling it out? if not you could try to take the spring out of a mechanical pencil and use it. look on xcm for the contoler tuts. they show how to pull the tirgger off


PsychoticWolf , MactasticMendez and Skullmaster, mike and 802Chives (and all the others:) are the Best Admins On ACIDMODS

Offline Tyler89--

  • Chief squatting Hard
  • *
  • Posts: 19
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Stuck Trigger
« Reply #2 on: June 07, 2010, 04:32:06 AM »
The trigger itself is not stuckin the depressed position, but once you fire, it wont stop. What is XCM?

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: Stuck Trigger
« Reply #3 on: June 07, 2010, 05:13:30 AM »
removal of the trigger assembly is quite simple, there are two platic hooks (one at top of mobo, one near bottom of mobo, at bottom of trigger, and three solder points. un hook the bottom hook, use a solder sucker to remove the solder at the three trigger points, and use your iron to push the three pins done through the mobo.

all the action of the trigger is handled by those three points, it sounds like the top and middle pin are bridged.

top pin is vdd bottom is gnd, and the center is the wiper

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal