Author Topic: need some help on my xrocker  (Read 1144 times)

Offline xMEx

  • ½ Pint
  • *
  • Posts: 30
  • Post quality +0/-0
  • Gender: Male
  • Deadly modder
need some help on my xrocker
« on: July 10, 2010, 05:44:50 PM »
Hey guys long time no post lol but I have a small problem with the bass on my xrocker I think I have the very first model not to sure but the song will come out fine except the bass if i move the plug around a lil (mostly push up) the bass will come in and it has a good thump to it and everything but I don't want to hold the wire up as i listen to music.

Is there a way to fix this?

Offline HiddenVenom

  • Gone 'shopping
  • Acid Modder
  • *
  • Posts: 835
  • Post quality +2/-0
  • Gender: Male
  • Photoschlop.
    • Star Legion
Re: need some help on my xrocker
« Reply #1 on: July 11, 2010, 02:18:01 PM »
Might just need tightening inside. Just check it to make sure nothing that isn't meant to be is loose, and make sure everything is firmly in the correct place.

Offline xMEx

  • ½ Pint
  • *
  • Posts: 30
  • Post quality +0/-0
  • Gender: Male
  • Deadly modder
Re: need some help on my xrocker
« Reply #2 on: July 11, 2010, 04:12:47 PM »
just tried that did not work might be the jack itself.

is that possible? (for the jack to go bad)

Offline HiddenVenom

  • Gone 'shopping
  • Acid Modder
  • *
  • Posts: 835
  • Post quality +2/-0
  • Gender: Male
  • Photoschlop.
    • Star Legion
Re: need some help on my xrocker
« Reply #3 on: July 11, 2010, 11:45:22 PM »
Check the connections to and from the jack first, one of them could be loose.

Offline FOOKz™

  • Hardware Modder
  • Moderator
  • E = MC² Mad Scientist
  • *
  • Posts: 2070
  • Post quality +37/-2
  • Electronics Expert Electrical Engineer
Re: need some help on my xrocker
« Reply #4 on: July 12, 2010, 11:48:29 PM »
Sometimes older audio jacks become oxidized and corroded over time. Clean the inside of the female jack with alcohol and a Q-Tip. Clean the male plug with alcohol and cotton balls.

If nether of of those solutions mentioned above work maybe you need to re-solder the joints on the jack itself.

Follow my Instagram and subscribe to my YouTube

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal