Well I guess some of you have seen the video of my PSP with the Fader, and well here is the tutorial on how to do it, it's really easy, don't worry
Supplies Needed:1 PSP
1 Fader PCB (can be found at
http://www.sickmods.netSome Kynar wire, different colors would be helpful too
Advanced Solder skills ( You will need to solder on the MoBo)
STEP 1. WIREING THE FADER PCBWire your LED Fader like this
And this is how it should look like in real life.
Well that was it, you are done with setting up the Fader, wasn't that hard, eh?
STEP 2. WIRING UP THE MOBOI don't have much to say at this part, since it's just soldering 2 wires, at the same spot like at the Music Pusle mod, so those people who already did this, can use their existing wires to make the Fader work.
STEP 3. MODE DECISIONNow you should have 2 wires left unsoldered, they are probably from the S1 and S2 spot from the fader, with those you can change the modes of your Fader. You can either solder them to a switch, or solder them to a Ground point, so the Modes are not changeable.
STEP 4. PLACEMENT OF THE PCBUnder the Wifi board folks, I put mine close to the Headphone jack, not to the very right, it wouldn't close then, a little more to the left, then it should close flawless.
Now, reassemble you PSP and enjoy if you have any questions feel free to visit the AcidMods Forums and ask
Make the Fader turn off over HoldThis is a little modification in the wireing. It's only a very little modification, so I think this will go well without pictures.
First, remove the wire that leads from + to PO. Now take your S1 , and solder it to your Hold switch. Your Fader now turn's off when you push the Hold switch down.