umm so if i add sethmods jitter would it work with this wireing set up ? or no ?
No.
Look at the wiring schematic I've listed below. P.S this is in Seths homepage in resources section.
Now all you have to do is wire your chip like this illustration. The pins on the chip that are labeled 1 & 2 with circles around them, u will want to wire 1 to X button & 2 to the Y button. Now if you want to make my universal jitter all u have to do is follow my list in the hex editor.
Hold until RT pull; Then click add new line
under the box labeled 1 click pull then......
Hold 21 MS; add new line then....
under that in the 1 box click release then......
Hold 19 MS; add new line: under the box labeled 2 click pull then....
Hold 21 MS; add new line: under the box labeled 2 click release then....
Hold 19 MS; add new line: under the box labeled 2 click pull then....
Hold 21 MS; add new line: under the box labeled 2 click release
There u go I re wrote the whole code for u. If you wire your chip like this u can run mods in normal order.l U can add at the beginning hold until LT is released then RT is pulled then u can have LT jitter aim assist. This will let u jitter hip shot then when u aim in it will fire normal! From here I have left u the tools needed to make your own mods. U can edit this jitter with the MS to tweak speeds or put UA on it. Read sethmods operating system in his main webpage! u can go forward/backwards by clicking tac or tac + LT. U have all the tools to be creative now.
Edit. If u want this to be compatible with Seth's YY jitter he has listed in his mod library then look at the boxes under 1 & 2. Only one of the two boxes will be operational. The operational box will be what button he has wired to Y. If u wire yours the same say his Y is in box 1 then u can wire X in box 2. U will just have to edit my setup by switching 1& 2 around.