ROL Xbox Controller Help!!!!!!!!

[PAIN IS AWESOME]

I was putting different leds into my controller and i accidently pulled off both pads for number 2 led how could i solder this on as i have tryed and failed horribly

[whitetop]

i had this on led 1 just follow the middle trace on the board from the led you will find a pin hole solder some wire to them then your led bet make sure it works before soldering to the pad

[PAIN IS AWESOME]

Thanks I also Found on my matrix i can solder a wire from a vdd to the positive of the led and ground it on the wire and works still thanks again