This is a topic about my second GCSE project, Just the Ideas and such because most of you know more than my teacher and can correct me.
So what I'm trying to make is a Mood Light Controlled a piece of
QTC controlling a RGB LED.
The Process diagram.....block.....thingy
Input > Process > OutputPressure on the QTC PICAXE-08 Different colours
The QTC just acts as a Variable Resistor, so I am going to use the ADC input. I found this program
main: ; make a label called ‚main
readadc C.1,b0 ; read ADC1 into variable b0
if b0 > 120 then top ; if b0 > 120 then do top
if b0 < 70 then bot ; if b0 < 70 then do bot
low B.0 ; else switch off 0
low B.4 ; and switch off 4
goto main ; jump back to the start
top: ; make a label
high B.0 ; switch on 0
low B.4 ; switch off 4
goto main ; jump back to start
bot: ; make a label
high B.4 ; switch on 4
low B.0 ; switch off 0
goto main ; jump back to start
so i just have to edit that program and this is my first foray into the world of programs so...
this is what i came up with
main: ; make a label called main
readadc 1 , b0 ; read ADC1 into variable b0
if b0 > 255 then red ; if b0 > 120 then do top
if b0 > 170 then green ; if b0 < 70 then do bot
if b0 > 85 then blue
low B0 ; else switch off 0
low B1
low B2 ; and switch off 4
goto main ; jump back to the start
red: ; make a label
high B0
wait 2 ; switch on 0
low B1 ; switch off 4
goto main ; jump back to start
green: ; make a label
high B1
wait 2 ; switch on 4
low B0
low B2 ; switch off 0
goto main ; jump back to start
blue:
high B2
wait 2
low B0
low B1
goto main Just realised that this makes it flash, added a "wait" tag
