Author Topic: Creating your own circuit boards [NOT FINISHED]  (Read 2423 times)

Offline FOOKz™

  • Hardware Modder
  • Moderator
  • E = MC² Mad Scientist
  • *
  • Posts: 2070
  • Post quality +37/-2
  • Electronics Expert Electrical Engineer
Creating your own circuit boards [NOT FINISHED]
« on: August 29, 2010, 09:38:58 PM »
You will need:

Express PCB (Free) or AutoCAD] 2002 or later
any type of Computer Printer
Access to Toner Copier or printer
High Gloss Paper or special PCB Transfer Paper
A PCB ironing station or a cloths iron
Copper clad board
Ferric Chloride concentrate 80% by volume or greater (most is)
steel wool
An industrial grade Sharpie or super permanent marker
isopropyl alcohol (rubbing alcohol)
rubber gloves
safety glasses
funnel
baking soda
a plastic-rubber tub

Optional Things (but help the process)
fish tank air pump
air pump hose
sponge
plexi-glass vertical board stand
5 liter (2 gallon) container (storage of waste acid)



Overview:

Section 1 ~
- You will pick a schematic and sketch it on the computer aided design (CAD) software
- When the design is final and you're ready to continue you're going to print
- Check for errors and copy the print to your transfer paper
- Ready to transfer to the Copper board!

Section 2 ~
- clean! clean! clean! the board! Leave no finger prints!
- You will use the heat transfer method to get the tone from the paper to the copper board
- When transfer is complete mark all incomplete or insufficient areas with permanent marker
- warm the acid in water, shake well, prep work area for etching process.

Section 3 ~
- place board on optional board stand and dip entire setup into the acid bath
- turn on bubbles and keep track of time; occasionally checking consistency
- when desired etching is reached remove PCB from acid and wash with cold water
- clean with baking soda and rubbing alcohol; let dry then drill holes for your parts.
- Clean work area up, properly dispose/recycle used PCB enchant acid leave no mess behind.

You're done.

















ExpressPCB, EAGLE, PROTEL, CADSTAR, ORCAD, CIRCUIT MAKER, P-CAD 2000, PCB ELEGANCE, EDWIN, VISUALPC, BPECS32, AUTOENGINEER, EXPERT PCB, CIRCAD, LAYOUT, CIRCUIT LAYOUT, MCCAD, DREAM CAD, E-CAD, POWERPCB, PCB ASSISTANT, PCB DESIGNER, QCAD, QUICK ROUTE, TARGET 3001, WIN CIRCUIT 98, BOARD EDITOR, PCB, VUTRAX, CIRCUIT CREATOR, PADSPCB, DESIGN WORKS, OSMOND PPC, LAY01, SCORE, GElectronic, PRO-Board, PRO-Net , CSIEDA, VISUALPCB, WINBOARD, ULTIBOARD, EASY PC, RANGER, PROTEUS, EPD - Electronics Packaging Designer , AutoTrax Eda, SprintLayout, CADINT, KICAD, Merlin PCB Designer, FREE-PCB, TinyCAD, WINQCAD, Pulsonix, DIPTRACE.
« Last Edit: April 05, 2011, 02:09:00 PM by FOOKz »

Follow my Instagram and subscribe to my YouTube

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal