stealth installs have one wire going to the tact button on the motherboard of the 360 controller so you can use the sync button to change modes. if i put that one wire to a new tact button that i drilled a hole for, which pad on the motherboard would i have to solder to the other pin on the tact button to make it functional?
there are three pins on the original sync button, you solder the one wire coming from the PIC with the stealth code to the middle one normally. i will solder that one wire to the tact, and try one of each of the other pads next to the middle one on the motherboard tact switch and see if that works. if it works i will reply it works. but i still would very much like an answer if anyone knows!!! thanks !!
and can i solder more then one wire to that pad for multiple stealthed codes to work the same? thanks!