Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
(ps. neo and whitetop please stay ontopic adn stop hating, there are only few people that are doing this stuff and we shouldnt start hating eachtother, just come with usefulle tips or tell me if u like it or not and leave it with that. cuz this hating stuff doesnt solve anything.)
hey im on topic and did my mod job just some cry baby will not give up it takes 5-10min to sand the 5mm led to a good size to fit in the ps button and takes less than 2min to replace with a 3mm now can you tell me which is the easiest if neo cannot get his head out his own ass and relies this now if it was me doing the post crap why has he not reported me ???( plus thx for the bad ones neo not like i care as its been said before post Post quality does not mean anything so caryy on makes it look better anyway )on topic as none have been done on the ps3 controller try on that thread i gave you on my first reply on the button leds or you could a wire ring and put 4 smd's on it and put it around the buttons to light them up saving drilling the buttons.
so i redid all the wiring and its alot better now, it didnt solve the problem of pointing up all the time but after blowing into the sensor thingy and removing all the extra solder that was on it it was fixed. but now i have a different problem, it wont turn back on .... but ye, i will take it apart again tomorrow i think and see what i can do.i also want to put rapid fire in all of my controllers but anyone has a suggestion of what chip i need to use wich is easy to install and not too difficult to use?and if my voltage drops to 2.4 after 5 leds is it smart to put another 3/5 in it????