Author Topic: Someone installed some rapid fire in the new control with matrix2?  (Read 1310 times)

Offline sQs

  • ½ Pint
  • *
  • Posts: 33
  • Post quality +6/-5
  • Gender: Male
  • Acidmods User
It may say something about how it works, and if set made ​​as installed in the old matrix, please comment something about

Offline hyper999

  • Acidmods Alumni
  • Millennium Poster
  • *
  • Posts: 1158
  • Post quality +544/-3
  • Research and Development
Re: Someone installed some rapid fire in the new control with matrix2?
« Reply #1 on: May 10, 2011, 07:52:22 AM »
kingmike said, in the thread about it being found, that he had tested rf on it and it worked just like it did on the original mx

Offline sQs

  • ½ Pint
  • *
  • Posts: 33
  • Post quality +6/-5
  • Gender: Male
  • Acidmods User
Re: Someone installed some rapid fire in the new control with matrix2?
« Reply #2 on: June 20, 2011, 09:43:27 PM »
Someone who is already installed, what point is recommended to take the positive current?,
In the first PCB Matrix, the current taken from a point that is slightly below LT but that point will not appear in PCB Matrix 2, when the current took the same point is taken for CG/CG2 not working properly.
Today and tried to take the current point TP4 that the bottom of the PCB and I to run correctly, do you think could damage the power to take control of this?

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal