Author Topic: PulseVU2 wierd issue on ps3  (Read 1091 times)

Offline The End of A Heartache

  • Granny Spanker
  • *
  • Posts: 411
  • Post quality +3/-0
  • Gender: Male
  • Mr. Martinez
PulseVU2 wierd issue on ps3
« on: September 27, 2011, 11:43:35 AM »
Havent been on here in along time

I have looked for answer and really no one can help me on this, its kind of wierd

I searched on this forum and looked through many threads but no one can give me an answer.

I have wired my pulseVU2 properly with the momentary push switch connected on the +pad and the SW pad, from the SW i connected a 10kOhm resister to the -pad on the PulseVU2.


As indicated on this photo




I have the OP wired to a bipolor slide switch. Its set on off for now so i can go through the fade modes and dimmer.

And connected two 5mm White LED with a 150Ohm resister and connected + end to the ps3 mobo and the - end to the VU on the pulse2 chip.

My forward voltage is 5v on the Ps3 board. Using the powersupply connection on the mobo.



When i turn on the ps3 and wait for the Pulse2 i see a dime light of my test LED but it quickly fades out.

When i hold the momentary push switch the LED begin to fade in mode 1, But when i release it stops.

Do i have the momentary push switch polarity backwards?



 
...emo freak out! >.< ........

random is fun

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal