Console Modding------ ( Here you can talk about your favorite Consoles ) > Tutorials
XBOX360 spi/usb flasher by darkstar
Anonamous:
IMAGE IS NOW CORRECT
Binaries and Files to make the above
Ok first things first. Instead of using a 12 mhz resonator, we are going to use a 12Mhz crystal and 2 22pF capacitors. Also, instead of the 220nF capacitor we will use a .047uF capacitor.
With that read/write takes 2-5 minutes. LPT cable takes 2 hours.
I am really too lazy to write a tutorial. That is darkstars usb/spi nand flasher design. And you must use a usb connector, cutting off an end of a usb cable does not work for some reason.
Parts List: Quantity
12Mhz Crystal: 1
22pF capacitor: 2
.1uF capacitor: 1
USB Connector: 1
PIC18F2455: 1
100 ohm resistors: 5
10k ohm resistors: 2
.47uF capacitor: 1
Pickit 2 (or other programmer to program the microcontroller)
Here are the Eagle Files for anybody interested. I did in fact create these. So if you decide to post these files anywhere else, please give me credit. I was going to just print the image to file or export it, but no matter what it does not scale the image properly. So just open the file in eagle and print it. Eagle Files
Rodent:
Looking great and thanks for parts list . which program should we use to program the PIC18F2455
Anonamous:
it depends on what you use to program it. I use a pickit2 so I used the program that came with it. Once you program it and put it into the circuit the bootloader is activated so you only need to program it once.
Anonamous:
The image is now correct. I will hopefully soon be etching some boards and if they come out good enough I may sell some in the bst thing.
magic_man185:
I also made a pcb layout, to etch a board for this design, I just haven't had time to etch the board. Anonamous, have you actually tried just using a cable without the USB connector? I was planning to just use a cable, because I didn't want to have to drill through the board to mount a USB connector on it.
Navigation
[0] Message Index
[#] Next page
Go to full version