Console Modding------ ( Here you can talk about your favorite Consoles ) > XBOX 360

XBOX 360 Slim power pinouts

(1/3) > >>

whitetop:
if you have any higher quality picture please add.

TRY THIS AT YOUR OWN RISK ACIDMOD OR I WILL NOT BE HELD RESPONSIBLE OF ANY HARM OR DAMAGE.


 
     
     


[smg id=2771] [smg id=2772]

Johan1973:
The way you have marked up the voltages, it seems to use -5V, -12V, and -3.3V which can not be right. But to be on the safe side, better mark it +5V, +12V, +3,3V so that no-one applies negative voltage from an unsuitable supply.

Fareham dave:
is this the slimline E 2013 console motherboard?

Gizmo613:
No, Tis Not That Motherboards.

BDaD:
I have done a case / light mod on a slim (using ‘blackburn’s voltage points diagram)  I now want to do the same to a ‘E’ but I can’t find information to where the voltage (particularly 12 Volt) points and ground points are, so I can connect LEDs or LED strip lights has anyone located them. I know the motherboard is different as I have seen it -- see link-

https://www.ifixit.com/Teardown/Xbox+360+E+Teardown/15062

Navigation

[0] Message Index

[#] Next page