Console Modding------ ( Here you can talk about your favorite Consoles ) > XBOX 360

XBOX 360 Slim power pinouts

<< < (3/3)

BDaD:
Thanks again for your help. It would be appreciated if you were able to do some voltage testing on the Xbox 360 E motherboard if the opportunity arises. I will not be doing any work on the case MOD of my “E” until after Xmas as I am too busy with work at present. I am just doing my “homework” now, so that when I am ready to do the Mod, it should be plane sailing.

BDaD:
Xbox 360 E Power pinouts --- Use this information at your own risk.
I tested the Xbox 360 E Voltage pinout points by checking for continuity to establish the ground points then soldered insulated wire to all of the solder points on the bottom of the motherboard underneath the power in socket. I then reassembled the Xbox except the top outer plastic casing and then tested it while the Xbox was on and fully functioning, as per photos, also see link  http://youtu.be/ZG3SCzEKi8s

Rodent:
Nice job  and thank you for helping with this thread also i been super busy  and forgot about this post.
i recently just did the same thing on the corona shown here
https://www.acidmods.com/forum/index.php/topic,43650.0.html

BDaD:
Thanks --- I am just a beginner compared to you. Your sound activated LEDs look pretty complicated.
Do you think this thread needs to include 'Xbox 360 E pinouts' in the title?

Rodent:

--- Quote from: BDaD on March 21, 2015, 11:48:53 PM ---Thanks --- I am just a beginner compared to you. Your sound activated LEDs look pretty complicated.
Do you think this thread needs to include 'Xbox 360 E pinouts' in the title?

--- End quote ---

the sound activated led is pretty simple install took me like 25 minutes to wire it  and the xbox 360 E slim motherboard is same as a corona  and Trinity motherboards on the bottom of  the board   and only a slight difference to the original pic above

Navigation

[0] Message Index

[*] Previous page