Author Topic: matrix 2 controller vcc?  (Read 1559 times)

Offline 3D0kassiah

  • Acid Modder
  • *
  • Posts: 809
  • Post quality +19/-2
  • Gender: Male
  • Acidmods User
matrix 2 controller vcc?
« on: April 03, 2012, 04:44:55 AM »
i got ahold of a silver matrix 2 controller looks like i can install hazers flex rf but where can i grab power from any ideas?
« Last Edit: April 03, 2012, 04:45:19 AM by 3D0 »
Tracey: f off Rodent
rodent:i would of flew it to bill gates and shoved it up his a$$

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: matrix 2 controller vcc?
« Reply #1 on: April 03, 2012, 05:19:43 AM »
its matrix, so you will need an opto, at which point you can pull from the battery for main power.

Offline 3D0kassiah

  • Acid Modder
  • *
  • Posts: 809
  • Post quality +19/-2
  • Gender: Male
  • Acidmods User
Re: matrix 2 controller vcc?
« Reply #2 on: April 03, 2012, 05:35:16 AM »
isnt the point of an opto is because matrix cg2 etc have an unswitched power source meaning itll turn on without hitting the dome correct?
can i still use the battery power withut an opto i always take the battery packs out when im done using it anyway so not really n issue
Tracey: f off Rodent
rodent:i would of flew it to bill gates and shoved it up his a$$

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: matrix 2 controller vcc?
« Reply #3 on: April 27, 2012, 11:54:08 AM »
The point of the OptoCoupler is to make a switched source, so it's on when the controller is on, off when it's off.

If you pull the batteries, then just use TP1 for the power on the Matrix2.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal