BurnMeUp3 working in the opposite way in Matrix controller

[rafaliyo86]

Hi guys

I have installed BurnMeUp3 in a matrix controller (I have done it more times) but I have a strange problem. The controller works in the opposite way it should do it, I mean when I turn the rapid fire on, the controller shoot without pressing RT and If I press RT the controller doesn´t shoot

I have put all the resistors (like diagrams) and I have checked the wiring and I don´t find anything wrong

What is happening? Thanks in advance

[Rodent]

I would check all your connections also try it with out the controller case on it . I had issues before where i pinched a wire and caused it to do this. make sure you got your chip wired correctly also.

[rafaliyo86]

Yes, I have tried without the case even with another matrix controller I have and the same thing happens.

Could be the chip??

[Rodent]

make sure you don't have any of the connections bridged on the chip and make sure you got the chip wired correctly.. could be touching causing it to complete the trigger connection or do you have the trigger connection bridged?

[rafaliyo86]

Well I have changed the chip and it works fine now

[Rodent]

Well I have changed the chip and it works fine now

maybe you programmed too many times? idk or maybe program correctly


word of advice , to anyone that does installs always double and tripple check your work even if you have to take a break from it and rethink what you might have done wrong ( always good to ask for help also )