Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
It a good start thanks Mystic but I need one with the thumb stick's, D-pad and action bottom already mapped out. I hope to find at least a template with this mapped out If not I guess I might be able to do something on Microsoft paintthanks
Okie cool thanks again Mystic I think this might help a lot more then doing it all by hands haha. A little trial and error will help line up the holes right I have two set of 1 foot by 2 feet long sheet of carbon fiber vinyl So I am sure I can get this setup right Cheers for good luck
Not a problem I'm glad I could have been of some help, and I'm sure the second link I sent ya will help greatly with cutting out the proper holes for the buttonsGood luck getting your skin together Need anymore help, I'm here to lend a hand
I have a good valid vita template somewhere. Just gotta find it. I think I only have rear panel but Ill check..
Thanks ran into some issue, one of them being no ink for the printer haha the second actually has to do with the first link to the template for the vita -.-It doesn't add up well to the actual vita, the corner are badly drawn, the edge's are about 1/4 inch wider and the upper and lower are also way to long.I am working with the template and working on some modification. The important part is to get the window size right but I don't have ink right now and its to late to run to any office supply store.I'll post picture of what I have so far
Oh wow, sorry about that crap of a template link. I would have tested it out myself, but I don't have either a printer or vita, so that's a bummer lol. I hope you were able to modify it correctly to fit properly, if not, then I'm sure 1TONpete or someone else will help ya out with it
Really nice work man.
Awesome and nice part in the tutorial there on the face plate cover keep up the good work.