Console Modding------ ( Here you can talk about your favorite Consoles ) > Xbox 360 Soft mods / JTAG support
RGH
nicmo:
Thanks for the info, I have some 100 ohms can it work with the diagram u send me?
3D0kassiah:
did you even see the schematic? you need 4x 3k3 and 1x 220ohm resistors and 3x 1n4148 diodes and make sure you check the polarity on the diodes
Rodent:
--- Quote from: nicmo on December 24, 2013, 10:49:13 AM ---Thanks for the info, I have some 100 ohms can it work with the diagram u send me?
--- End quote ---
you will need what is listed in the pic for the programmer shown here
R1 3k3 ohm Resistor (1)
R2 3k3 ohm Resistor (1)
R3 3k3 ohm Resistor (1)
R4 220 ohm Resistor (1)
R5 3k3 ohm Resistor (1)
D1 1n4148 dioide (1)
D2 1n4148 diode (1)
D3 1n4148 diode (1)
3k3 ohm Resistor you will need 4 of them
220 ohm Resistor you will need 1 of them
1n4148 diode you will need 3 of them
'
this is to build the programmer for the coolrunner
5X100ohm 1/4w 5% resistors
to be used with if your building a nand reader lpt
show here in steps 7 thru 9
https://www.acidmods.com/forum/index.php/topic,36590.0.html
nicmo:
Thanks for the help so far. I got my coolrunner on the weekend and I need diagram to install it and also should I program it before I try to install it? I haven't build the lpt cable though.
Gizmo613:
you can't program it unless you have the lpt cable built first.
The diagrams can be found using the TX J-Runner software. Head over to TX forums and download it.
Also how are you gonna read and write the nand? this is required to get your consoled to be rgh'ed.
If you feel you are not up to do this, there are members here who can offer the install sevices. eg: Rodent and myself.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version