Console Modding------ ( Here you can talk about your favorite Consoles ) > Xbox 360 Soft mods / JTAG support
System freezes
Rodent:
could be just over heating , first thing i would try is taking off the x-clamp and reapply some new artic silver 5 paste and try bolting down the heat sync like you would a normal rrod fix. using steel and nylon washers the spacing has to be right so that you do not flex the board and should be bolted thru the cage simple easy fix i would try before reflowing or reballing the console
nicmo:
This started after I rgh it. Could it cause fron flashing the nand? When I'm on fsd the temperature gauges look fine.
Rodent:
its possible i would rebuild the nand image and reflash it also double check your wiring and your solder points
nicmo:
--- Quote from: Rodent on March 21, 2014, 03:38:43 AM ---could be just over heating , first thing i would try is taking off the x-clamp and reapply some new artic silver 5 paste and try bolting down the heat sync like you would a normal rrod fix. using steel and nylon washers the spacing has to be right so that you do not flex the board and should be bolted thru the cage simple easy fix i would try before reflowing or reballing the console
--- End quote ---
what size washer and bold should i get seem the rrod fixwill do the trick because the heat sync was not seated properly, i press down on all four side and test and it didnt freeze.
Rodent:
--- Quote from: nicmo on March 23, 2014, 12:04:11 AM ---what size washer and bold should i get seem the rrod fixwill do the trick because the heat sync was not seated properly, i press down on all four side and test and it didnt freeze.
--- End quote ---
12mm phillips head will work
M5 Nylon Washers - 1 mm thick
M5 Steel Washers - 1 mm thick
how many will you will need will depend on the stack up to keep the heat sync and the motherboard from flexing. you want to make sure that you do not flex the motherboard best is to mount them thru the case. nylon wasers you will need 8 to 16 or 32 depending on the stack up !
steal washers i do not remember i only had to do this one time and i stacked them so that the the mother board sat flat against the cage and stand offs in the cage also you need 4 nylon washers to put against the bottom of the motherboard and top side for sure so you do not short the motherboard out against steal washers
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version