« previous next »
Pages: [1]   Go Down

Author Topic: Need help with a connector pinout  (Read 1395 times)

Offline neilthe4th

  • Guppy
  • *
  • Posts: 2
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Need help with a connector pinout
« on: May 10, 2018, 11:04:24 PM »
So my friend asked me to fix his plug and play controller cord that has gotten old, on the side of the connector to the controller I didn't take caution to see where eache cable went and the board itself doesnt specify. I'm hoping to find what each of the 7 pins of the controller respond to since I can see the buses that the solder points go to.

Basically I'm asking for a pinout of the port where the plug and play controller connects to. i hope it isn't too much trouble.







Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2611
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: Need help with a connector pinout
« Reply #1 on: May 11, 2018, 07:54:40 AM »
The 7 connections of the PnC connector just go to the controller, the 5 connection one needs the USB cable wired up to it.

On your second pic there, the back of the board, left to right.

5v (Red), D- (White), D+ (Green), GND (Black), GND (Shield)
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline neilthe4th

  • Guppy
  • *
  • Posts: 2
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Need help with a connector pinout
« Reply #2 on: May 13, 2018, 01:05:53 AM »
Thank you so much :D
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2611
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: Need help with a connector pinout
« Reply #3 on: May 13, 2018, 12:10:01 PM »
Welcome.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal