« previous next »
Pages: [1]   Go Down

Author Topic: 1537 ripped left trigger +motor pad  (Read 1304 times)

Offline domPL1

  • Guppy
  • *
  • Posts: 2
  • Post quality +0/-0
  • Acidmods User
1537 ripped left trigger +motor pad
« on: January 03, 2020, 08:24:50 AM »
Hi Guys,
I ripped positive lead of left trigger motor (SQ1). I tried to solder it to TP27 (using this thread https://www.acidmods.com/forum/index.php?topic=43204.0), but it's not working. Any ideas where I can get that lead elsewhere?
Thanks in advance

PS: I attached the best photo I could take
https://imgur.com/a/KOjm8dS
PS2: I tested motor. It's working fine.
« Last Edit: January 03, 2020, 09:31:18 AM by domPL1 »
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: 1537 ripped left trigger +motor pad
« Reply #1 on: January 03, 2020, 01:07:20 PM »
TP27 is dead as the trace goes thru SQ1 to TP27, so no SQ1 no TP27.

The only places you have left now are scrapping and using the Via/trace there at SQ2, pad 3 of U6 or pin 8 of U4.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline domPL1

  • Guppy
  • *
  • Posts: 2
  • Post quality +0/-0
  • Acidmods User
Re: 1537 ripped left trigger +motor pad
« Reply #2 on: January 03, 2020, 02:11:16 PM »
Thanks a lot. I used u4. On the other side of the board right before trace from it travels across. Again thank you very much :)
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: 1537 ripped left trigger +motor pad
« Reply #3 on: January 03, 2020, 03:16:03 PM »
Welcome.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal