Console Modding------ ( Here you can talk about your favorite Consoles ) > 360 Controllers / 360 Rapid Fire Controllers

buttom pairing not work

(1/1)

zis2104:
the buttom paring not working in this board....solution?

RDC:
Define not working.

Does the button click?
Are you holding it in for a few seconds? and do the LEDs ever spin?

It's a common ground button and the trace goes straight to pin 48 of U6.

I'd also clean up those button contacts to make sure they are open, sometimes weird things will happen if buttons are held down or there is enough mess there to partially conduct when it shouldn't. The A button looks messed with also.

You can plug it into a 360 with the PnC cable and it will force sync the controller to the console. Might need to do that and it will straighten out afterward.

zis2104:
I press the button and the LEDs turn on and off only, as if I had not pressed the button. It works if I attack it with the cable but I have to sell it and therefore I should lower the price.

Navigation

[0] Message Index