Console Modding------ ( Here you can talk about your favorite Consoles ) > Nintendo Switch

Nintendo Switch Pro Controller - regulated & switched voltage source?

<< < (2/2)

RDC:
What red circle?

That 4.2v sounds like it's the battery voltage though. Can't see what you did, so no real idea there yet.

Also, try to keep your LEDs setup to only draw 5mA or so, provided they will light up at that current or unless you just want them retina searing bright and a shorter run time of the controller.

Greendaycolt:

Greendaycolt:
I just reproduced the issue - I don’t think it has anything to do with the LEDs or any modifications. When I remove the battery and then reinsert it, controller won’t turn on wirelessly or charge unless I leave it alone with battery in for a few hours... Any idea why that would happen?

RDC:
Does it need to be plugged into the Switch and synced over USB when it's new? Pulling the battery could be wiping it clean, so to speak. Every now and then a 360 controller would get 'stupid' and you'd have to just plug it up with the PnC cable to the console and that would force sync it, then it would be fine.

Navigation

[0] Message Index

[*] Previous page