« previous next »
Pages: [1]   Go Down

Author Topic: 1537 MCU not Working!  (Read 836 times)

Offline renan.horste

  • Fart Sniffer
  • *
  • Posts: 48
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
1537 MCU not Working!
« on: September 21, 2020, 08:14:13 AM »
I still having a problem with my MCU board.
The controller don't turn on with the MCU, in TP6 and TP10 I don't have the 3.3v, and the traces are ok.
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: 1537 MCU not Working!
« Reply #1 on: September 21, 2020, 09:27:42 AM »
TP6 and TP10 on the 1537 MCU board are on the data/control lines between the MCU and the RF module. Check R9 and R10 (both top side of MCU board) they should measure 33ohms. If those are good, then the MCU or RF module has the issue.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline renan.horste

  • Fart Sniffer
  • *
  • Posts: 48
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: 1537 MCU not Working!
« Reply #2 on: September 21, 2020, 12:07:22 PM »
R9 and R10 have 33ohms, I already change de RF module.
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal