« previous next »
Pages: [1]   Go Down

Author Topic: looking for help  (Read 681 times)

Offline popahly

  • Guppy
  • *
  • Posts: 6
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
looking for help
« on: August 31, 2020, 04:23:30 AM »
Hello everyone, I have an old motherboard for the controller, I want to make bridges for damaged places. Just for training. Is there anyone to help me.



Thanks
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: looking for help
« Reply #1 on: August 31, 2020, 09:04:19 AM »
There are no easy to solder to spots on the DS4 controllers. You'll need to clean all of that up first with a Q-tip and some rubbing alcohol. Then follow the traces from the damaged areas and solder to what is left of the trace or follow it until it gets to a via and prep and solder it there.

Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline popahly

  • Guppy
  • *
  • Posts: 6
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: looking for help
« Reply #2 on: August 31, 2020, 01:50:27 PM »
Thank you very much, professor. Excuse my ignorance of this matter. Can you direct me more with just one example. I tried a lot to keep track of the points, but I failed.
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: looking for help
« Reply #3 on: August 31, 2020, 04:37:21 PM »
If I'm the teacher, then you should be learning. ;) Save the image there and use something like Paint or PhotoShop so you can zoom in and trace them out.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline popahly

  • Guppy
  • *
  • Posts: 6
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: looking for help
« Reply #4 on: September 01, 2020, 12:00:41 AM »
A big honor for me..I will do that. Thank you
Logged

Offline wickated

  • King of the Wii-tards
  • *
  • Posts: 176
  • Post quality +0/-1
  • Acidmods User
Re: looking for help
« Reply #5 on: September 05, 2020, 09:23:31 AM »
tips
1) dont use rosin flux with leadfree soldering repairs
2) joint from resistor goes directly to MCU but track is bold so u can scratch coating and solder jumper wire to it
3) for l3 button press solder  jumper wire in here :
Logged

Offline popahly

  • Guppy
  • *
  • Posts: 6
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: looking for help
« Reply #6 on: September 06, 2020, 05:21:13 AM »
Thank You so much..
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal