Author Topic: console customs max fire v2.5 troubleshooting  (Read 453 times)

Offline STIVIX

  • Guppy
  • *
  • Posts: 5
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
console customs max fire v2.5 troubleshooting
« on: January 02, 2021, 05:04:59 PM »
Whats up guys!

Installed this max fire v2.5 in my xbox one controller model 1697 and I'm getting zero response.  The controllers basic functions all work but when trying to engage any mod it has no response.  It's as if the mod isn't even hooked up.  Put the meter on it to ohm out my solder points to make sure there was no bridging on pins and then traced from pins to the main chip on the mod to make sure solder points where connected well.  Everything checked out.  Is it possibly a software update that made the chip obsolete?  Any help would be appreciated.  Thanks

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: console customs max fire v2.5 troubleshooting
« Reply #1 on: January 02, 2021, 08:39:09 PM »
Recheck all your solder joints, then go thru their user manual to make sure you're pressing everything correctly to make it work, then if it's still not working https://consolecustoms.com/about-contact-us/ is who you need to ask about it since they made it.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal