Author Topic: L2 and R2 input when moving analog sticks (Read 940 times)

zis2104 · « **on:** January 07, 2021, 02:57:19 PM »

i have two ps4 jdm 001 controllers that when i move the analog r2 and l2 they receive the input as if i was clicking them

LethalPrime · « **Reply #1 on:** January 07, 2021, 04:12:38 PM »

They use the same power Rail so either the thumbstick is bad or the trigger pads are bad, maybe both.

zis2104 · « **Reply #2 on:** January 07, 2021, 04:39:47 PM »

should i change the sensors? because i changed the circuit board

LethalPrime · « **Reply #3 on:** January 07, 2021, 04:55:14 PM »

If you mean the green film, that does nothing, that only completes the circuit. Your fault is on the actual pcb or trigger pads not the green film.

zis2104 · « **Reply #4 on:** January 07, 2021, 05:15:24 PM »

do I replace the analogs then? but if the error is on the circuit where I mount the green film then the cards are to be thrown away?

LethalPrime · « **Reply #5 on:** January 07, 2021, 05:43:17 PM »

Clean or replace the analog sticks
Still broken after that? Replace the trigger pads

wickated · « **Reply #6 on:** January 08, 2021, 06:58:42 AM »

left stick Y - R2
right stick Y - L2

if u walk forward while pressing r2 then change pot , its dead

zis2104 · « **Reply #7 on:** January 08, 2021, 08:23:01 AM »

When i move analogs r2 go itself, but i replace 1 analog but i used analog for ps4 controller slim/pro...is bad?

zis2104 · « **Reply #8 on:** January 09, 2021, 02:42:41 PM »

close the topic, i selled them by ebay.

News: